Operation Manual
Regulator
4 kW 560 V DC 40% Duty Cycle + 24 V DC
BAL9100-0126d-EN
www.conductix.com
original document
page 28 of 32
13
Disassembly and Re-use
If it is necessary to exchange a Regulator due to damage or to install it in another place, verify that no
damage will occur during disassembly.
For installation in another place observe the described mounting and commissioning instructions. Improper
application, installation or operation involve the danger of severe injuries to persons and damage to objects.
All electric work has to be carried out by qualified staff (IEC364 respectively, CENELEC HD 384 or DIN VDE
0100 and IEC 664 or DIN VDE 0110 and national safety rules).
Qualified staff, according to the safety regulations, are persons that are familiar with the installation,
assembly, commissioning and operation of the energy supply system and that have the appropriate
qualifications.
13.1
Safety Advice for Disassembly and Disposal
1.
Disconnect the IPT
®
system from the mains voltage.
2.
Make sure the system cannot be powered up again accidentally.
3.
After disconnecting the track supply from the supply voltage wait at least 5 minutes for internally stored
energy to discharge.
4.
Dismount the device.
5.
Dispose of components in a specific way
Recycling.
13.2
Recycling
The unit contains components that have to be disposed of in a specific way. If it is not used any longer, it will have to be recycled
properly. Dispose of the materials separately in accordance with the current regulations, i.e. separate circuit boards, aluminum
heatsink and housing, copper, etc. or hand over the unit to a recycling specialist.