Operation Manual
Track Supply 6 kW
80 / 125 A at 400 / 480 V
BAL9100-0124c-EN
www.conductix.com
Page 34 of 44
16
Fault diagnosis
If the Track Supply faults - e.g. no energy supply to the secondary components, check the LED display for
indication of possible cause. Refer section 7 “Control board hardware and failure indication” for LED status.
Attempts to repair or restart should be avoided! Do not use the system anymore as long as the error
is not located and repaired or defect components are replaced by trained personal!
After conclusion of the failure analysis, the Track Supply has to be protected against touching of live parts by
closed housing / covers. (See Safety hints in chapter 10.2 „General advice for the installation“).
Failure indication on the outside
LCD Display Window
Status lights on Display Board:
Green : Mains connected
Yellow : Warning In operation, but
conditions critical
Red
: Fault
Stopped due
to faulty conditions
For advanced status analysis see
chapter 7 “Control board hardware and
failure indication”.
