Condair DL II, Operation Manual

Page: 27 / 80

27 Operating the Condair DL control software
5.1.2 Humidity control indication field
If you press the humidity control indication field in the home screen, a window appears with further infor-
mation on humidity control (control mode: "On / Off" or "Demand") or the setpoint input (control mode;
"RH P" or "RH PI), depending on the current control mode.
09/01/2021 DL
07:00 pm
Home
Next Maintenance
1685 hr
Demand
Standby
0%
09/01/2021 DL
07:00 pm
Source
Control Mode
Signal Type Control
Analog
Demand
0-10V
Winterzeit
Status
– Source : Shows the source of the control signal
("Analog", "Modbus", "BACnet" or "IoT").
– Control Mode : Shows the current control mode
("On/Off", "Demand", "RH P" or "RH PI").
– Signal Type Control : Shows the control signal
type used.
Note: This setting only appears if the control
mode is set to "Demand".
09/01/2021 DL
07:00 pm
Winterzeit
Setpoint
41 %
09/01/2021 DL
07:00 pm
Home
Next Maintenance
1685 hr
Humidity
Standby
0%
– Setpoint : Setting of the desired humidity setpoint
value in %rH.
5.1.3 Maintenance indication field
If you press the Maintenance indication field in the home screen, a window appears with further informa-
tion on maintenance.
09/01/2021 DL
07:00 pm
Home
Next Maintenance
1685 hr
Demand
Standby
0%
09/01/2021 DL
07:00 pm
Next Maintenance
Next Disinfection
Remain. Ag-Ion Capacity
Operating Hours
1685 hr
50 d
0.5 Ah
315 hr
Winterzeit
Service
– Next Maintenance : Shows the remaining time
in hours until the next system maintenance is
due.
– Next Disinfection : Shows the remaining time
in days until the next disinfection is due.
Note: Only appears if the setting "Disinfections
Timer" has been activated in the engineering
level of the control software.
– Remain. Ag-Ion Capacity : Shows the remaining
capacity of the silver cartridge in Ah until the next
replacement is due.
– Operating Hours : Shows the number of operat-
ing hours since initial commissioning.