24
7.
General instructions
7.1
General instructions
The use of high-quality individual components and the built-in safety and monitoring devices
ensure a very high level of operational readiness.
Should a malfunction nevertheless occur, the fault can be easily identified and the cause elimi-
nated using the fault table listed below.
If serious faults occur, contact the manufacturer
(see nameplate).
7.1.1
Reporting faults to the manufacturer
To ensure effective troubleshooting assistance, have the following pieces of information ready:
Order number (if available)
Item number (if available)
System type
Operating logs and maintenance logs (if available) for the last year
7.1.2
Fault indication and reporting
In the event of an error, the control unit is programmed to react as follows:
RLY2 alarm output is activated
Fault indication in the display
Faults and their elimination
WARNING!
The elimination of faults may only be carried out by qualified and instructed
specialist personnel in compliance with the safety regulations in Section A of
these operating instructions.
Before it is put to work, the system must be disconnected from the power supply and
secured against being switched back on unintentionally.
All lines must be de-pressurised.
INSTRUCTION
Observe the corresponding instructions from section F – Control unit
Summary of Contents for CONDAIR SOFT
