Comtech EF Data CDM-760, Installation And Operation Manual

Page: 183 / 441

Ethernet Interface Operation Revision 4
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
7–16
7.4.4.2.3 Admin | Upgrade
Beginning with Firmware Version 1.4.1, the Administrator may use this page to manage the
CDM-760 Firmware Upgrade process.
Figure 7-9. Admin | Upgrade Page
Firmware Upgrade
Do the steps displayed in the
Firmware Upgrade
section of this page to transfer the extracted
firmware update image ZIP file (available from www.comtechefdata.com or Comtech EF Data
Product Support) from the User PC to the modem‘s Flash memory.
Note that Steps 6 through 8 prompt you to use the Firmware Image Config section of this page
to finalize the process.
Firmware Image Config
•
ReFLASH Status – The messages that display here guide you through the file’s PC-to-modem
transfer process.
• Active Image – This
read-only
item displays the active firmware image that is loaded upon
power-up/boot up of the unit. Note that the file transfer process overwrites the
non-active
firmware image. In order to make that firmware upgrade as the active image load, you must
re-define the Next Reboot Image accordingly.
•
Next Reboot Image – This
read-only
item displays the active firmware image – 1 or 2 – that
is loaded upon power-up/boot up of the unit.
•
Click [Set Image 1] or [Set Image 2] to specify which firmware image is loaded upon power-
up (bootup) of the unit.
•
Click [Reboot Modem] to reboot the CDM-760. You will need to re-enter your user
credentials to resume use of the HTTP Interface.