9
Section 2
Introduction
This manual contains complete operating, maintenance and calibration information for the
Compliance West USA MegaPulse Defib-5PF-002 Impulse Tester.
•
In case of trouble, the test can be immediately terminated at any time by turning the rear-
panel power switch to the OFF position.
•
Before the test can commence, the unit must be armed by pressing the
CHARGE
Button.
The test will not begin until the
TRIGGER
Button is pushed.
•
Operator instructions are printed on the rear panel for quick reference.
•
Voltage is discharged by a resistor bank within the MegaPulse tester upon test completion.
Discharge progress is shown on the front panel meter.
Your tester is warranted for a period of one year upon shipment of the instrument to the original
purchaser.
Specifications
Specifications for the MegaPulse Defib-5PF-002 are listed in the table below and the component
designations are shown in Figure 1 and Figure 2. For impulse waveform look at
Figure
3 and Figure 4.
ELECTRICAL
Output Voltage:
0 - 5000 V tolerance ±1%
Main Capacitance:
0.13 uF ±10% Type A, 0.50 uF ±10% Type B (600,000 cycles life)
Voltage Control:
Digital Set point adjusted by frontal VOLTAGE knob or by PC
TestMinder.
Voltage Display:
4 Digit LED Display.
Voltage Meter resolution:
2V
Duty Cycle:
1 pulse every 20s.
Selectable Input Voltage:
120V~ 60Hz
240V~ 50Hz
ENVIROMENTAL
Operating Temperature:
15 - 40 ºC
Relative Humidity Range:
Altitude
0 - 90% non-condensing
0 - 3000 meters
GENERAL
Dimensions:
17” wide x 15.75” high x 17” in deep
Weight:
50 lbs. approx.
Summary of Contents for MegaPulse Defib-5PF-002
