26
Section 7
Maintenance and Calibration
WARNING:
THESE SERVICE INSTRUCTIONS ARE FOR USE BY QUALIFIED PERSONNEL ONLY. TO AVOID
ELECTRIC SHOCK, DO NOT PERFORM ANY SERVICING OTHER THAN THAT CONTAINED IN THE
OPERATING INSTRUCTIONS UNLESS YOU ARE QUALIFIED TO DO SO.
Service Information
The MegaPulse D5-PF tester is warranted to the original purchaser for a period of 1 year. This warranty does not
cover problems due to misuse or neglect. Malfunctions which occur within the limits of the warranty will be corrected
at no charge. Mail the instrument postpaid to the manufacturer. Dated proof of purchase is required for all in-warranty
repairs. The manufacturer is also available for calibration and / or repair of instruments that are beyond their warranty
period. Contact the manufacturer for a cost quotation. Ship the instrument and your remittance per the instructions
given by the manufacturer.
General Maintenance
To avoid contaminating the PWB with oil from your fingers, handle it by the edges or wear gloves. If the PWB
becomes contaminated, refer to the cleaning procedures given later in this section
Cleaning
CAUTION
Do not use aromatic hydrocarbons or chlorinated solvents for cleaning. These solutions will react with the
plastic materials used in the instrument.
Clean the front panel and case with a mild solution of detergent and a damp sponge. Clean dust from the PWB with
clean, dry, low pressure (<20 psi).
Calibration Information
The MegaPulse D5-PF has been fully calibrated at the factory in accordance to our published specifications. It is
recommended that you have this instrument re-calibrated and safety check done at least once per year. The procedure
consists on internal components tolerance verification and calibrating the meter reading to agree with the capacitor
bank.
The Calibration procedure must be performed by qualified personnel. Contact Compliance West USA for the latest
calibration procedure. Have ready the serial number of the MegaPulse D5-PF tester.
Summary of Contents for MegaPulse D5-PF
