Compliance West MegaPulse 1.2x50-12.3PF-1, Instruction Manual

Page: 14 / 31

10
Fuse Replacement
There is a user-replaceable fuse (F1) located on the rear panel of the instrument. It is located
behind a door in the Power Inlet-Power Switch-Fuse Holder device. The fuse rating is noted on
the rear panel. Do not attempt to replace it with a fuse of any other rating.
Use the following procedure to replace the fuse F1:
1.
Turn the power switch to the OFF position.
2. Unplug the instrument from the source of supply.
3. Remove the power inlet cord from the instrument.
4. Using a small screwdriver, pry open the fuse holder door.
5. Replace the fuse with a new one of the correct rating.
6. Replace the fuse holder door and power inlet cord.
Front and Rear Panel Features
Before using your Tester, take a few minutes to become familiar with the use of its controls,
indicators and connectors. The front panel features of the MegaPulse are shown in
Figure 6
and
described in
Table 2
. The rear panel features of the MegaPulse are shown in
Figure 7
and
described in
Table 3.
.