13
Figure 7. Controls, Indicators, Connectors – MegaPulse 1.2x50-12.3PF-1 500ohm 0.5J Rear Panel (image for reference only)
ITEM NO.
NAME
FUNCTION
1
Appliance Inlet / Fuse holder /
Power Switch
Use supplied cordset to connect the MegaPulse 1.2x50-12.3PF-1 500ohm 0.5J tester to an appropriate
source of supply. Fuse holder provides access for Fuse replacement, and the Power Switch is used to turn
the tester ON and OFF.
2
RS-232 Interface (Optional)
Allow the communication between the tester and computer interface; a RS-232 to USB is available.
3
Interlock Switch (Optional)
Emergency Stop
Close: Enables the tester buttons for operation.
Open: Stops any process in the tester and disables the buttons. The
TRIGGER
and
CHARGE
Indicators
will be blinking
4
Fuse replacement warning /
Rating of power supply
Specifies replacement fuse and required supply voltage.
Table 3. Control, Indicators, Connectors – MegaPulse 1.2x50-12.3PF-1 500ohm 0.5J Rear Panel
1
4
2
3
Summary of Contents for MegaPulse 1.2x50-12.3PF-1
