Compliance West HT-10KVDC, Instruction Manual

Page: 12 / 29

7
Section 3
Operation
This section describes how to set up and make measurements with the HT-10KVDC. We
recommend that you read the entire section carefully so that you can use all of its features.
Setting up the HT-10KVDC
The HT-10KVDC is shipped in a special protective container that should prevent damage during
shipping. The container should include the following:
•
The HT-10KVDC Dielectric Withstand Tester
•
A black 18 AWG Test Return Lead (Alligator Clip/Banana Plug ends)
•
A red 18 AWG High Voltage Test Lead (Alligator Clip/High Voltage Plug ends)
•
A Power Cord.
•
This Instruction Manual
Use the original shipping container for subsequent shipping. If the original shipping
container is not available, be sure that adequate protection is provided to prevent damage
during shipment.
Remove the Tester from its container and place it on a test bench.
AC Line Voltage Requirements
Connect the HT-10KVDC only to the voltage source per the rating on the rear panel.
Fuse Replacement
There is a user-replaceable fuse (F1) located on the rear panel. The fuse rating is on the rear
panel.
Use the following procedure to replace the fuse F1:
1. Turn the power switch to the O or off position.
2. Unplug the HT-10KVDC from the source of supply.
3. Remove the power cord from the HT-10KVDC.
4. Open the fuseholder door.
5. Replace the fuse with one of the correct rating.
6. Replace the fuseholder door and power inlet cord.