Installing the Server
4-25
Compaq Confidential – Need to Know Required
Writer:
Cynthia Dresden
Project:
Compaq ProLiant DL580 Server Setup and Installation Guide
Comments:
Part Number:
159213-003
File Name:
e-ch4 Installing the Server.doc
Last Saved On:
4/5/01 2:26 PM
Attaching the Cable Management Arm
After the server is mounted in the rack, begin installing hardware for cable
management. Rack mounting hardware provided with your server includes a
cable management arm, fasteners, hinges, and screws.
The cable management arm attaches to the server's cable management arm
bracket and to the rear frame of the rack. All cables to and from the server are
tied to this arm. The two hinges allow the cable management arm with
attached cables to swing out of the way when you need to access the rear of
the server. Use the following procedures to install the extended cable
management arm bracket and to attach the cable management arm.
Installing the Extended Cable
Management Arm Bracket
The extended cable management arm bracket fastens to the rear of the rack
server's chassis. The bracket provides an attachment point for the cable
management arm from the server to the rear frame of the rack.
Attach the extended cable management arm bracket to the back of the server
with two 6-32 x 312 Torx screws.
NOTE:
Attach cable management hardware after the server is mounted into the rack.
Figure 4-15. Attaching the extended cable management arm bracket to the
server