Removal and Replacement Procedures
2-59
Power Button/LED Cable
To remove the power button/LED cable:
1.
Power down the server. See the “Powering Down the Server” section in this chapter.
2.
Extend or remove the server from the rack. See the “Preparation Procedures” section in
this chapter.
3.
Remove the access panel. See the “Access Panel” section in this chapter.
4.
Disconnect the power button/LED cable from the SCSI backplane
.
5.
Disconnect the power button/LED cable from the power button/LED board
.
1
2
Figure 2-58. Removing the power button/LED cable
Reverse steps 1 through 5 to replace the power button/LED cable.
