E-10
Compaq ProLiant ML350 Generation 2 Server Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer:
Jennifer Hayward
Project:
Compaq ProLiant ML350 Generation 2 Server Setup and Installation Guide
Comments:
Part Number:
236843-002
File Name:
k-appe LEDs & Switches.doc
Last Saved On:
9/4/01 11:16 AM
Redundant ROM Settings
IMPORTANT:
Switching ROM images can also be done through RBSU. Use the following
procedures when RBSU is inaccessible. For information on accessing redundant ROM
options through RBSU, see Chapter 5, “Server Configuration and Utilities.”
To switch from the current ROM to the backup ROM, perform the following
steps:
1. Power down the server.
2. Set the system configuration switch positions 1, 4, 5, and 6 to the
on
position.
3. Power up the server. The ROM will beep and halt when the ROM
images have been swapped.
4. Power down the server and reset all system configuration switch
positions to the default
off
position.
5. Power up the server.
SCSI Device Jumper Settings
No two SCSI devices connected to the same SCSI controller can have the
same SCSI ID. If another SCSI device is connected to the same controller,
check the SCSI ID on the device before beginning the installation procedure
for the additional device. The SCSI ID is set by jumpers located on each
device. For more information. refer to your SCSI device option
documentation.
