INS_RLXE4GE24MODMS_REV– 20 Dec 2017 PAGE 62
INSTALLATION AND OPERATION MANUAL
RLXE4GE24MODMS
TECH SUPPORT: 1.888.678.9427
MEP Performance Monitor Configuration
This page allows the user to inspect and configure the performance monitor of the current MEP
Instance.
Performance Monitoring Data Set
Enable
When enabled this MEP instance will contribute to the 'PM Data Set' gathered by
the PM Session.
Loss Measurement
Enable
Loss Measurement based on transmitting/receiving CCM or LMM/LMR PDU can be
enabled/disabled - see 'Ended'. This is only valid with one Peer MEP configured.
Priority
The priority to be inserted as PCP bits in TAG (if any). In case of enable of
Continuity Check and Loss Measurement both implemented on SW based CCM,
'Priority' has to be the same.
Frame rate
Selecting the frame rate of CCM/LMM PDU. This is the inverse of transmission
period as described in Y.1731. Selecting 300f/sec or 100f/sec is not valid. In case
of enable of Continuity Check and Loss Measurement both implemented on SW
based CCM, 'Frame Rate' has to be the same.
Cast
Selection of CCM or LMM PDU transmitted unicast or multicast. The unicast MAC
will be taken from the 'Unicast Peer MAC' configuration. In case of enable of
Continuity Check and dual ended Loss Measurement both implemented on SW
based CCM, 'Cast' has to be the same.
