48
Port Trunk – Aggregator Information interface
6.14.3 State Activity
Having set up the LACP aggregator on the tab of Aggregator Setting, you can configure
the state activity for the members of the LACP trunk group. You can select or cancel the
checkbox beside the state display. When you remove the select mark to the port and
select
button, the port state activity will change to
Passive
.
!
Active:
The port automatically sends LACP protocol packets.
!
Passive:
The port does not automatically send LACP protocol packets, and
responds only if it receives LACP protocol packets from the opposite device.
[NOTE]
1.
A link
having either two active LACP nodes or one active node can
perform dynamic LACP trunk.
2.
A link
having two passive LACP nodes will not perform dynamic LACP
trunk because both ports are waiting for an LACP protocol packet from
the opposite device.
Summary of Contents for CWGE9MS
Page 20: ...19...
Page 37: ...36 Event Configuration interface...
Page 50: ...49 Port Trunk State Activity interface...
Page 60: ...59 Group Configuration interface Select button...
