CommScope RUCKUS ICX 7550, Hardware Installation Manual

Page: 62 / 141

8. Enter the following commands to set the port configuration and read-only passwords.
device(config)# enable port-config-password john
device(config)# enable read-only-password sam
Performing the Factory Reset
Complete the following steps to perform a factory reset.
1. Remove power from the switch.
2. Press and hold the reset button while applying power to the switch.
3. Release the reset button after all of the system LEDs flash amber.
When all the system LEDs blink green, all the configuration data is erased and the switch is returned to its factory configuration. When all the
system LEDs are solid green, the erase process is complete and the system reloads. Once reloaded and the SYST LED is steady green, the factory
reset is complete.
Recovering from a Lost Password
If a password has been configured for the device but the password has been lost, you can regain Super User access to the device using the following
procedure.
Recovery from a lost password requires direct access to the serial port and a system reset.
1. Start a CLI session over the serial interface to the RUCKUS ICX device.
2. Reboot the device.
3. While the system is booting, before the initial system prompt appears, enter b to enter the boot monitor mode.
4. Enter no password. (You cannot abbreviate this command.)
5. Enter boot. This command causes the device to bypass the system password check.
6. After the console prompt reappears, assign a new password.
Configuring an IP Address for the Device
You must configure at least one IP address using the serial connection to the CLI before you can manage the device using the other management
interfaces. You can use the classical IP network masks (Class A, B, and C subnet masks, and so on) or Classless Interdomain Routing (CIDR) network
prefix masks.
• To enter a classical IP network mask, enter the mask in IP address format. For example, enter "10.157.22.99 255.255.255.0" for an IP
address with a Class C subnet mask.
• To enter a prefix number for a network mask, enter a forward slash (/) and the number of bits in the mask immediately after the IP
address. For example, enter "10.157.22.99/24" for an IP address that has a network mask with 24 significant ("mask") bits.
1. At the opening CLI prompt, enter the following commands.
device> enable
device# erase startup-config
device# configure terminal
Initial Setup and Verification
Configuring an IP Address for the Device
RUCKUS ICX 7550 Switch Hardware Installation Guide
62 Part Number: 53-1005648-04