CommScope RUCKUS ICX 7550, Hardware Installation Manual

Page: 38 / 141

FIGURE 26 Positioning the Device in the Rack
1. Screws, 10-32 x 5/8-inch, panhead Phillips 2. Retainer nuts, 10-32
Attaching the Rear Brackets to the Rack Posts
Complete the following steps to attach the rear brackets to the rack posts.
1. Slide the right rear bracket into the right front bracket and the left rear bracket into the left front bracket.
2. Adjust the rear brackets to the rack depth.
3. Attach the right rear bracket to the right rear rack post using two 10-32 x 5/8-inch panhead screws and two retainer nuts, as shown in
Figure 27 . Use the upper and lower holes in the bracket.
4. Attach the left rear bracket to the left rear rack post using two 10-32 x 5/8-inch panhead screws and two retainer nuts. Use the upper and
lower holes in the bracket.
5. Tighten all the 10-32 x 5/8-inch screws to a torque of 25 in-lb (29 cm-kg).
Mounting the Device
Four-Post Rack Mount Installation (ICX-RMK-4POST-TL)
RUCKUS ICX 7550 Switch Hardware Installation Guide
38 Part Number: 53-1005648-04