TECP-90-814 • Rev C • October 2020
Page 43
© 2020
CommScope
. All Rights Reserved.
e. When the microcables with non-functional connectors have been spliced, proceed to step 14.
12. Rewind any remaining slack on the spool tray. Apply a small amount of tension to the
microcable as the slack is being rewound on the spool. Make sure the cable is wound snug
inside the spool tray so the cable doesn’t snag on anything.
13. Using the red latch, rotate the tray clockwise and pull the tray forward to the locked
operation position as shown in
.
Figure 56. Pulling Tray Forward to Locked Operation Position
14. When done, be sure to pull the center red latch forward to first locking position. This will
lock the tray to prevent further spool rotation.
15. Locate and install the front port designation plate as shown in
. Slide in the
designation plate until it reaches the detents and snaps into place
1
7
Red
2
19
Red
1
8
Black
2
20
Black
1
9
Yellow
2
21
Yellow
1
10
Violet
2
22
Violet
1
11
Rose
2
23
Rose
1
12
Aqua
2
24
Aqua
Table 3. Optical Port Designation
MICR
O
CABL
E
OPTIC
AL
PORT
FIBER
COLOR
MICR
O
CABL
E
OPTIC
AL
PORT
FIBER
COLOR
25910-A
1
2