Commend SIP Series
Configuration via Web Interface
2.0/0612
41
Menu items:
Disabled:
A running conversation can not be cancelled at the SIP station (i.e. only at the respec-
tive remote station).
If a “
Call Time Limit
” is configured (see below), then the conversation is cancelled automa-
tically after this defined time.
Button
<x>
: Besides the “Call Time Limit” the conversation can only be cancelled with the cor-
responding button at the SIP station.
Any Button:
Besides the “Call Time Limit” the call can be cancelled via pressing any button of
the SIP station.
Call Time Limit:
Time in seconds, after which a running conversation (between two SIP devices) is
cancelled automatically.
If the “call time limit” shall be deactivated, then “
0
” has to be entered.
Allow Arbitrary Dialing:
If the checkbox is activated, it is possible to dial any desired number. I.e.
it is possible to dial a number which is not saved in the
”Phonebook”
(if the checkbox is deactivated,
only call destinations saved in the phonebook can be dialled).
As soon as the number is entered, the Enter button has to be pressed, in order to set up the call.
LED Configuration
In this section, settings for the LED behaviour for the following states can be configured:
Outgoing Call
– Outgoing call from the SIP station
Incoming Call
– Incoming call from the SIP station
In Call
– Running conversation between two SIP devices
Standby
– Idle state (inactivity) of the SIP station
Error
– Error in connection to SIP server, signalling or other problems
Following settings regarding LED behaviour (for the states listed above) are possible:
On:
LED is permanently on
Off
: LED is permanently off
Flashing:Fast
: LED blinks in a fast rhythm
Flashing:Slow
: LED blinks in a slow rhythm
Note:
The feature is very useful for emergency situations, where e.g. only the emergency center shall be
able to cancel the call – so it is ensured that the initiator of the emergency call can not cancel the call
unintentionally.
Note:
The number and the labelling of the buttons in the drop-down menu depends on the used station ver-
sion (
see page 10
) and the number of configured direct dialling modules in use (
see page 49
).
Note:
This feature only refers to stations with full keypad and registration at a SIP server. At serverless
operation no arbitrary dailing is possible.
Note:
Idle state = registered at SIP server or in case of operation without server: “ready for operation”.
Note:
The LED (currently) can indicate the colour RED only.