APR/16/2002
6979 USA
11
87a
86
87
30
85
Fuse
Gray Wire
+12V Or Ground
Depending On System
Requirements
+12V
Electric Device
CHANNEL 2
H9/3. Pink wire –(-) 200ma
PROGRAMMABLE OUTPUT (See Start Feature
I – 5
Programming)
2 STEPS UNLOCK OUTPUT -- (Factory default setting)
The 2 steps unlock feature will work for the most fully electronic door lock circuit. The vehicle must have
an electronic door lock switch (not the lock knob or key switch), which locks and unlocks all of vehicle's
doors. When wired for this feature, press the disarm (or unlock) button one time will disarm the alarm
and unlock the driver's door only. If, press disarm (or unlock) button two times within 3 seconds, the
alarm will disarm and all doors will unlock.
FACTORY SECURITY DISARM SIGNAL OUTPUT –
This wire is designed to disarm a factory installed security system. This wire sends a negative (-) 1
seconds pulse upon a remote start and remote door unlocking. Some factory systems must be disarmed
to allow remote starting. In most cases, this wire may be connected directly to the factory alarm disarm
wire. The correct wire will show nagative ground when the key is used to unlock the doors or trunk. This
wire is usually found in the kick panel area in the wiring harness coming into the car body from the door.
START STATUS (Shock Sensor By-Pass Control) OUTPUT–
This wire is designed to by-pass shock sensor module. This wire will supply an output at all times the
remote start is operating plus an additional 3 seconds after the remote start unit turn off.
H9/4. ORANGE WIRE – (-) 500ma GROUNDED OUTPUT WHEN ARMED --
This wire will become grounded when the alarm is armed. The current capacity of this wire is 500mA. This
output can control starter disable, when an intrusion is detected and the system is triggered. The vehicles
prevent from any unauthorized starting.
87
87a
85
30
86
IN4003 Diode
H9/4
: ORANGE wire
from control module
“Start”
“On”
Violet wire
X
Cut
White wire
Orange wire
“Acc”
“Off”
Starter
H1/1
VIOLET wire (Starter output)
form Heavy Gauge wire harness
Yellow wire to
Ignition Switch
H9/5. WHITE WIRE – (-) 200ma DOME LIGHT CONTROL OUTPUT –
This wire becomes grounded when the dome
light controls circuit active. The current capacity
of this wire is 200mA. This wire can control the
operation of the interior lights. An optional 10
Amps relay can be used to this system for interior
lights operation.
a). Upon disarming, the interior lights will remain
on for 30 seconds.
b). If the vehicle is violated, the interior light will
flash for the same duration as the siren.
87a
86
87
30
85
Fuse
White Wire
+12V
Door
Switch
Courtesy
Light
H9/6. Brown/White WIRE –(-) 200ma PROGRAMMABLE OUTPUT
(See Start Feature
I – 6
Programming)
HORN OUTPUT – (Factory default setting)
