APR/16/2002
6979 USA
19
1. Activate the warn-away (first stage optional sensor), system will emit a short chirp.
2. Activate the full alarm (second stage optional sensor), system will emit a long chirp.
3. Continue to test the optional sensor until reach the proper sensitivity.
4-c. Test the Zone 5 / Wireless PIR or Door Switch:
Press and release the transmitter
button again. [3] LED flash, [3] siren/horn chirps to indicate your
are in optional wireless PIR or Door switch test mode.
Trigger sensor
Siren chirps
Zone 5 / Optional wireless PIR or Door Switch
5
Adjusting and Testing The On-Board Shock Sensor (Zone 1).
The Zone 1 / shock sensor has been built in this system, you can use this mode to test and adjust sensitivity
of the shock sensor. The installer can save time to adjust and test sensitivity of the shock sensor without
using the traditional arming/disarming procedures.
Enter:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch
6
times and hold it until
three
chirps with a long chirp is hearing then release the
valet switch. You are now in the Alarm feature
‘III’
programming mode.
Adjusting and Testing:
There are 16 steps of adjustment for the shock sensor.
1. Press the transmitter
button once will decrease sensitivity by one, each time an decrease is made
the siren/horn chirp will respond with [1] chirp, while 2 chirp indicates the minimum of sensitivity.
2. Press the transmitter
button once will increase sensitivity by one, each time an increase is made the
siren/horn chirp will respond with [1] chirp, while 2 chirp indicates the maximum of sensitivity.
3. Back the factory default setting: Press and hold the transmitter
or
button for 4 seconds until A (1)
long chirp from siren/horn, The sensitivity of the shock sensor will Back the factory default setting.
4.
To test the shock sensor sensitivity adjustments, apply a shock to the vehicle.
a. Activate the warn-away (first stage shock sensor), system will emit a short chirp.
b. Activate the full alarm (second stage shock sensor), system will emit a long chirp.
5. Continue to test the shock sensor until reach the proper sensitivity.
REMOTE START FEATURE PROGRAM MODE.
START FEATURE “
I
” PRORAMMING:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch
8
times and hold it until
four
chirps with a long chirp is hearing then release the
valet switch. You are now in the Start feature
‘I’
programming mode.
3. Press and release the transmitter button ‘A’ corresponding to the feature ‘A’ you want to program.
Press
T
ransmitte
r
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulse
Three Chirps /
LED three pulse
Four Chirps /
LED four pulse
1
10 minutes run time
20 minutes run time
30 minutes run time
5 minutes run time
2
Factory alarm disarm
with channel 2 on
Without this feature
3
Constant parking
light output
Flashing parking
light output
4
Door lock before
start
Without this feature
5
H9/3 Pink Wire =
Two step door
unlock output
H9/3 Pink Wire =
Factory Security
Disarm Signal
Output
H9/3 Pink Wire =
Start Status (Shock
Sensor Bypass
Control) Output
6
H9/6 Brown/White
Wire = (-) 200ma
Horn Output
H9/6 Brown/White
Wire = Factory
Security Rearm
Signal Output
