1/2/02
ALA550
7
2 STEP DOOR UNLOCK WIRE CONNECTION FOR
GROUND SWITCHED DOOR LOCKS
Cut Existing Unlock Wire
X
Lock
Unlock
OEM Door Master Lock Switch
To All Other
Door Lock
Motors
10-Pin
Plug
From
Alarm
H7/7 Brown Wire
OEM Driver's
Door Lock
Motor
Existing Neg.
Lock Wire
Existing Neg.
Unlock Wire
86
30
85
87
87A
+ 12V
H4/3 Green
Wire
Door Lock
H4/1 Blue
Wire
Door Unlock
3 Pin Plug
To Alarm
OEM Door
Lock Relay
2 STEP DOOR UNLOCK WIRE CONNECTION FOR
POSITIVE SWITCHED DOOR LOCKS\
Cut Existing Unlock Wire
X
Lock
Unlock
OEM Door Master Lock Switch
To All Other
Door Lock
Motors
10-Pin
Plug
From
Alarm
H7/7
Brown Wire
OEM Driver's
Door Lock
Motor
+ 12V
Existing Pos.
Lock Wire
Existing Pos.
Unlock Wire
30
87A
87
86
85
+12V
+ 12V
OEM Door
Lock Relay
86
30
85
87
87A
H4/3 Green
Wire
Door Unlock
H4/1 Blue Wire Door Lock
3 Pin Plug
To Alarm
PROGRAMMING
A. THE TRANSMITTERS:
Enter:
1. Turn the Ignition switch ‘OFF/ON’ 3 TIMES and stay in ON position. Within 15 seconds.
2. Push the Valet switch 3 times and hold it until a long chirp is hearing then release the valet switch. You
are now in the Transmitter programming mode.
Program:
1. Press button on one of the transmitter until the siren responds with a confirming chirp the first transmitter
is now programmed.
2. Press button on the second transmitter until the siren responds with a confirming chirp, the second
transmitter is now programmed.
3. Apply the same procedure to program 3rd and 4th
.
Exit:
Turn Ignition to 'OFF' position, or leave it for 15 seconds. A 3 long chirps to confirm exit.
Note: If more than 4 transmitters programmed, the system only kept the last 4 transmitters.
B. ALARM FEATURES PROGRAMMING:
ALARM FEATURE “
I
” PRORAMMING:
1. Turn the Ignition switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch
2
times and hold it until
one
chirp and a long chirp is hearing then release the
valet switch. You are now in the Alarm feature
‘I’
programming mode.
3. Press and release the transmitter button ‘A’ corresponding to the feature ‘A’ you want to program.
a.
The siren chirps and LED pause will indicate the latest setting.
b.
The factory default setting is always [1] LED flash, [1] chirp.
4 Depress the transmitter button ‘A’ to change the feature. Simple re-depressing the transmitter button ‘A’
again until the module advances to your desired setting.
a.
In this case, Press button ‘A’ again, the module would advance to [2] LED flash, [2] chirp. Press button
‘A’ again, the module would advance to [3] LED flash, [3] chirps etc.
4. Depress the transmitter button ‘B’ corresponding to the feature ‘B’ you wants to program.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulse
Three Chirps /
LED three pulse
Four Chirps /
LED four pulse
1
All Chirp on
Siren Chirp on only
Horn Chirp on only
All Chirp off
