16
ALARM ACT ACRTON
→
(Figure 1-2-19)
Figure1-2-6
①
NUMBER: default is on 1
②
ALARM ACT ACTION: in Figure 1-2-6 move the rocker up and down to make the cursor point to the alarm act action, and then
move the rocker to the right to enter the alarm act action menu. As shown in Figure 1
-
2-19
Figure 1-2-19
I ACTION TYPE : this option is to set the type of alarm linkage action. Preset point, linear scan, cruise scan, pattern scan, group
scan, continuous scan and interval scan optional. Default type is no action.
II ACTION NUM : this item chooses the number of the action type for the above action type. When the selected item is "---", the
current action type has no optional number, that is, the current action number cannot be set.
③
INPUT TYPE: normal open or normal close, default is normal close.
④
OUTPUT TYPE: normal open or normal close, default to normal close
⑤
DWELL TIME: 0-255 seconds is optional, default is 0 seconds
⑥
ACTIVATE AUS : on or off optional, default is off. When the alarm output is set to open, if there is an alarm input, the alarm signal
will be output and the alarm device, such as the alarm bell, will be activated.
⑦
CLEAR CURRENT
：
In Figure 1-2-6, move the rocker up and down so that the cursor points to delete the current, and then move
the rocker to the right to delete the current alarm settings.
1.2.7 IR SETTING
In Figure 1-2-1, move the rocker up and down so that the cursor points to the IR setting, and then move the rocker to the right to
enter the IR setting menu. Figure 1-2-7 shows.
ALARM SETTING
NUMBER 1
ALARM ACT ACTION
INPUT TYPE CLOSE
OUTPUT TYPE CLOSE
DWELL TIME 0
ACTIVATE AUS OFF
CLEAR CURRENT
BCAK
EXIT
ALARM ACT SETUP
ACTION TYPE PRES
ACTION NUM 3
BACK
EXIT
