13
③
PATTERN SETUP: in Figure 1-2-3, move the rocker up and down to point the cursor at pattern setup, and then move the rocker
to the right to enter the pattern setup menu, as shown in Figure 1-2-10.
Figure 1-2-10
I NUMBER: 1-4 optional. PTZ camera can set 4 groups pattern scan. Patterns scan realizes recording and playback of arbitrary
trajectory, and its recording parameters include horizontal speed, vertical speed and zoom multiples. Each pattern can record 500
commands.
II SET PATTERN: In the menu of Figure 1-2-10, move the rocker up and down so that the cursor points to the set pattern, and
then move the rocker to the right to enter the set pattern state. Move the rocker up and down and left and right to control the camera
to rotate horizontally and vertically, and change the camera magnification according to [WIDE], [TEIE]. The PTZ camera records the
trajectory of the camera and the camera zoom information in real time. Press
［
CLOSE
］
to save the pattern scanning settings and
return to the pattern scanning settings menu.
III CALL PATTERN: In Figure 1-2-10, move the rocker up and down to point the cursor at calling pattern, then move the rocker to
the right to run the pattern scan, and move the rocker arbitrarily back to the pattern scan settings menu.
IV CLEAR CURRENT: In Figure 1-2-10, move the rocker up and down so that the cursor points to delete current pattern, and then
move the rocker to the right to delete the current pattern scan.
④
CONT- SCAN SETUP: in Figure 1-2-3, move the rocker up and down so that the cursor points to the cont-scan setup and then
move the rocker to the right to enter the cont-scan setup menu, as shown in Figure 1-2-11.
Figure 1-2-11
I NUMBER: 1-4 optional. PTZ camera can set 4 groups group scan.
II SPEED: 1-10 optional, default is 9. 1 level is minimum speed, 10 level is maximum speed.
III SET CONT-SCAN :IN Figure 1-2-11, move the rocker up and down so that the cursor points to the editing group, and then
move the rocker to the right to enter the editing group interface
PATTERN SETUP
NUMBER 1
SET PATTERN
CALL PATTERN
CLEAR CURRENT
BACK
EXIT
CONT-SCAN SETUP
NUMBER 1
SPEED 9
SET CONT-SCAN
CALL CONT-SCAN
CLEAR CURRENT
BACK
EXIT
