CombiSteel 7455.0900, User Manual

Page: 9 / 62

9
www.combisteel.com
5 OPERATING INSTRUCTIONS
5.1 LIGHTING INSTRUCTIONS
DO NOT OPERATE THE UNIT UNLESS IT HAS BEEN INSTALLED AND
COMMISSIONED BY AN AUTHORIZED PERSON.
BEFORE TURNING ON THE MAIN GAS SUPPLY, CHECK AND ENSURE THAT
ALL THE VALVES ARE IN THE “OFF” POSITION.
THIS EQUIPMENT IS DESIGNED FOR COMMERCIAL CATERING PURPOSES AND WILL
GENERATE SIGNIFICANT HEAT. HOT SURFACES WILL CAUSE BURNS. A HAZARD AND
RISK ASSESSMENT MUST BE UNDERTAKEN BY OWNERS AND ALL OPERATORS MADE
AWARE OF THESE.
NOTE: Ensure the gas supply to the equipment is turned ON.
WARNING:
When open top burners adjacent to the backguard or the side of a grill plate
are operated at high heat and covered by large cooking vessels (i.e. pots,
pans etc), dispersing heat may cause discolouration and or distortion of the
adjacent metal surface.
5.2 OPEN TOP BURNERS
Pilot Flame Ignition

Starting from the OFF● position, press the control knob and rotate to the PILOT
★
position.

Press the knob and ignite the pilot flame with a taper or flame gun - keep the knob fully depressed for
15 seconds after the pilot lights.

Release the knob and check the pilot flame stays alight. If the pilot flame did not stay alight, repeat the
ignition procedure.
Open Burner Ignition

Slightly depress the control knob and rotate to the desirable flame level

When the automatic valve senses that the pilot is alight, the gas flow to the main burner is opened.
Pilot Standby Position

To turn the main burner off and keep the pilot ON, slightly depress the control knob and rotate to the
PILOT
★
position.
Shut Down/Pilot OFF

Slightly depress the control knob and rotate to the OFF ● position.
NOTE: If the pilot flame were accidentally extinguished, the flame failure safety device would operate and cut
the gas flow to the main burner. It would then be necessary to re light the pilot by following the above procedure.
Before attempting to light the appliance, the cover, if so equipped, shall be opened.
Make sure all valves are closed before turning on the gas supply.