Locking Clip
37
SECTION 10 - Installing the Infant Car Seat without the Base
38
SECTION 10 - Installing the Infant Car Seat without the Base
LAP ONLY BELT
To install with a Lap only belt pass the belt
from one side of the infant car seat to the
other. Fit the belt under the lugs in front of
the handle.
Pull the belt tight!
LAP/SHOULDER BELT
To install with a Lap/shoulder belt pass the
Lap belt from one side of the infant car seat
to the other. Fit the belt under the lugs in front
of the handle.
Fit a Locking Clip to the Lap and Shoulder
belts just above the vehicle belt latch plate.
Pull the belts tight!
NOTE: A Locking Clip MUST be used with
a Lap/Shoulder belt with a tongue that
moves freely along the belt, or with a
Lap/shoulder belt where the Lap portion
of the belt cannot be tightly secured.
LOCKING CLIP
A Locking Clip is supplied with the infant car
seat and is stored at the back of the infant
car seat.
To fit the Locking Clip, first fit to the Lap Belt
as shown opposite, then fit the Shoulder Belt
through the Locking Clip over the top of the
Lap belt.
WARNING: If the Locking Clip is not used
where required, the infant car seat will
not be held securely in place.
Remove Locking Clip from the vehicle belt
when not in use.
DO NOT use the Locking Clip as a vehicle
belt shortener.
