6
Secure the device to the wall on a solid
surface able to support 25 kg on four
mounting points. The wall plugs
provided are intended for use in
materials such as concrete. For other
types of material, use appropriate
mounting hardware.
Do not install this device near a heat
source or any flammable material.
Do not install this device in a damp,
oily, or dusty environment, or
in a location where it is directly
exposed to sunlight or water. Failure
to apply this recommendation could
cause electrocution or fire.
It is recommended that you call on
a qualified technician or a repair
company to install or repair the device
or to update the software via the USB
key. Failure to apply this
recommendation could cause a risk of
electric shock, fire, injury, or
malfunction of the device.
Do not touch the device's power plug
if your hands are wet.
The device must be earthed and
connected via a standardised
230-Vac/16-A Phase/N Earth
connector and protected by a 30-mA
circuit breaker. Failure to apply this
recommendation would lead to a risk
of electrocution or injury.
The fuse must be replaced by
a qualified technician or repair
company.
If the power cable is damaged,
immediately ask the manufacturer or
certified repair technician to
replace it.
Insert the power supply plug to that the
cable hangs down.
If the power cable is plugged in
upside down, the cable could break,
causing a fire or electrocution.
Do not climb onto the machine. Do
not place any object (such as laundry,
lighted candles, lighted cigarettes,
metallic objects, etc.) on the machine.
Do not place any container of water or
filter bowl on the machine.
Do not attempt to look at the UVc
lamp when it is switched on. This
could cause irreversible damage to
the retina and skin.
Do not touch the UVc lamp with
bare hands.
In case of traces of dust or water
leakage in the device, disconnect
it and contact COMAP after-sales
service. Shut off the water supply
and switch the device to Bypass
Mode (shunting the water circuit).
When commissioning the device, start
by supplying it with water and check
that there is no leakage in the device
or the installation before connecting
it to the electricity supply.
In the event of an extended absence
of power supply, whether deliberate
or not, disconnect the power cable,
remove the protective cover, and set
the battery unit switch to OFF. Apply
these steps in reverse when normal
power is restored.
If the machine is releasing a chemical
odour or smoke, disconnect it
immediately and contact COMAP
after-sales service.
Modifications can lead to injury and/
or property damage. Modifications
applied to this device by a third
party are not covered by the COMAP
service guarantee. COMAP accepts no
liability in the event of safety issues or
damage resulting from modifications
made by a third party.
Do not apply violent shocks or
excessive force to the device or in
CAUTION
CAUTION
WARNING
WARNING
CAUTION
CAUTION
CAUTION
Summary of Contents for Komeo
Page 2: ......
Page 27: ...27 26 ...
