18
WORK
16.
Pressing the accelerator pedal (7), the machine starts moving and the central and side brushes will
rotate.
ATTENTION:
adjust the working speed according to the amount of waste and
debris to be collected
To make a reverse manoeuvre, pull the accelerator pedal (7) upwards. The machine will begin to move
backwards.
ATTENTION!
The reverse speed is lower than the forward speed to comply
with current health and safety standards.
Press the front flap-raiser pedal (8) when working with bulky waste, to allow the central brush to reach and
collect it.
WARNING!
Do not hold the pedal for long.
In order to achieve a correct vacuum action, clean the filter every 10 minutes and always before any
discharge of the debris hopper.
To do this, proceed as follows:
1.
Stop the machine and engage the parking brake
2.
Lift the central brush by turning the left lever (1) clockwise
3.
Lift the side brush if lowered, by rotating the right lever (2) clockwise
4.
Activate the filter shaker on the filter by pressing the switch (6) on the instrument panel; this will
stop the vacuum action automatically.
WARNING!
Do not keep the switch (6) pressed longer than ten seconds,
repeat this operation two or three times.
Periodically check the filling of the tray and if necessary proceed to empty it. Keep in mind that the
weight of the waste collected is proportional to the specific weight of the material swept. In the case of
heavy material such as sand, earth, gravel, etc. the tray should ideally not be filled more than 70%,
otherwise it may be difficult to empty.
25.
EMPTYING THE DEBRIS HOPPER (MANUAL MOVEMENT)
The machine is NOT equipped with a device to warn you when the debris hopper is full, so it is a good
idea to empty it frequently while working.
7
7
8
6
2
1