11
MACHINE PREPARATION
9.
SIDE COMPONENTS OF THE MACHINE
The side components of the machine are identified as follows:
15.
Blinking light (optional)
16.
Rear carter lifting handle
17.
Storage compartment carter
10.
REAR COMPONENTS OF THE MACHINE
The rear components of the machine are identified as follows:
18.
Rear carter retainer
19.
Debris hopper handle
20.
Debris hopper retainer
11.
FRONT MACHINE COMPONENTS
The front components of the machine are identified as follows:
21.
Steering column front carter
22.
Front machine headlight
12.
TYPE OF BATTERY
To power the machine it is necessary to use:
•
liquidelectrolyte lead traction batteries
•
sealed traction batteries with gas recombination or gel technology.
OTHER TYPES MUST NOT BE USED.
The batteries must meet the requirements laid out in the norms: CEI EN 60254-1:2005-12 (CEI 21-5) +
CEI EN 60254-2:2008-06 (CEI 21-7)
The battery compartment can house four 6V or two 12V batteries
For a good operating performance, we suggest the use of four 6V/210 Ah C5 batteries
13. BATTERY MAINTENANCE AND DISPOSAL
For maintenance and recharging, comply with the instructions provided by the battery manufacturer.
Particular attention must be paid when choosing the battery charger, if not supplied, since there are
different kinds according to the type and capacity of the battery.
When the battery reaches the end of its working life, it must be disconnected by expert, trained personnel,
then lifted (using the grips and suitable lifting devices) to remove it from the battery compartment. DEAD
BATTERIES ARE CLASSIFIED AS DANGEROUS WASTE AND MUST BE DELIVERED TO THE
AUTHORISED BODIES FOR CORRECT DISPOSAL.
15
16
17
18
19
20
21
22