Columbia Coronado 25, Owenrs Manual

Page: 72 / 115

SECTION 5
Page 27
5.13 (continued)
Looking at the back of the frame, there are slots cut from the inside of
the frame across the wood to the outside. These are drain holes and
should be at the bottom of the box. Fasten the frame by screwing,
countersinking, and plugging the holes.
Grab rails are mounted on the cabin top, as shown on the Deck Assembly
drawing. They axe fastened as follows:
All cabin top teak hand rails used shall have at least one stainless
steel thru-bolt at each end fastening them to the deck. Hand rails with
more than two grips shall be fastened with thru-bolts as illustrated
below. The intermediate grips shall be fastened with stainless steel
selftapping screws.
The eyebrow trim is pre-cut and shaped to fit the cabin top. Follow the
scribe line on the cabin to install this. After installing them some shaping
and sanding may be needed to make them fair. He careful you do not drill
through the cabin when drilling your screw holes. Mount with countersunk
stainless steel self-tapping screws. Finish with teak plugs over dolphinite
sealant.