Columbia ParCar Expediter EX21-24A, Service Manual

Page: 71 / 94

Figure 8-5
Section 8
–
Body and Chassis
HORN BUTTON
1 . Remove wires from back of horn button. Remove
retainer nut from front of button and remove it.
Connect wires to new horn button and install it with 2 .
retainer nut.
SEAT
Tilt the seat forward to gain access to the battery
compartment.
To remove the seat, disconnect the wiring harness
connectors. Remove the hinge screws, then remove the seat.
To re-install, attach the seat to the hinges using the hinge
screws, then reconnect the wiring harness connectors.
SEAT BACK
The seat back can be reclined to carry a passenger. Lift up on
the seat back assembly and lay flat (Figure 8-5). To put the
seat back in the upright position, lift seat back up and forward
and engage the retaining pins into the mounting plate slots
while pushing down on the seat back.
To remove seat back, remove the screws, washers, bushings
and lock nuts. Remove the seat back.
To re-install, attach the seat back to the seat back mounting
plates using the original hardware. Make sure bushings are
positioned between seat back rail and mounting plates.
HANDRAILS
The handrails are attached to the body using 5/16- 18 x 7/8”
screws and 5/16-18 lock nuts (Figure 8-5).
BRAKE LIGHT
To replace the brake light, disconnect the brake light wiring
harness and pull the light through the rubber grommet. Install
new light and plug in the wiring harness (Figure 8-6).
FUSE BLOCK
located in the battery compartment and is attached with 10-24
nylok nut and 10-24 x 5/8 screw.
Figure 8 - 4