Columbia ParCar Expediter EX21-24A, Service Manual

Page: 63 / 94

Section 7 - Rear Wheels,
Rear Suspension & Axle Assembly
To seat the bearing past the O-ring, a leather or plastic mallet
may be required.
NOTICE: Intermediate shaft assembly must be
supported by hand as not to damage gear teeth. Use
care if using a hammer to coax shaft and gear into
correct position.
8. After flanged side bearing is seated past snap ring groove,
install snap ring (16). Repeat procedure for opposite side
bearing and snap ring.
Figure 7 - 21
Figure 7 - 22
Figure 7 - 23