Columbia ParCar Expediter EX21-24A, Service Manual, Page: 61 / 94

Section 7 - Rear Wheels,
Rear Suspension & Axle Assembly
14. Using a brass drift pin, drive the intermediate shaft (9) from
the flange side of housing. Shaft should travel far enough
to allow engagement of I.D. bearing puller.
remove
intermediate bearing (11) from flange side of
housing. See Figure 7-16. 18 Pull input shaft assembly (12) from housing. The input shaft assembly should slide out easily.
If resistance is
16. Repeat steps 1-15 for intermediate bearing on opposite encountered, a slide hammer may be required. See
side.
Figure 7-18.
17. Remove oil seal (30 not shown) and snap ring (16) from
. 12 Punch or drill a 1/8” diameter hole near the center of
each intermediate cup plug (17). Insert a suitably sized
sheet metal screw until the metal bore plug is forced out
of the bearing bore. See Figure 7-14.
. Remove snap rings (16) from each intermediate bore. 13
See Figure 7-15.
NOTICE : Shaft and gear assembly must be supported
by hand as not to damage gear teeth.
NOTICE : Small end of intermediate shaft and gear
assembly must be tilted toward opening in bottom of
housing for removal.
15 . Using an I.D. bearing puller attached to a slide hammer,
Figure 7 - 15
Figure 7 - 1 6
Figure 7 - 17
Figure 7 - 18
Figure 7 - 19