Coltene CanalPro CL2, User Manual

Page: 10 / 108

CanalPro
TM
CL2 Cordless Handpiece
10
Power Switch
Charging LED
Handpiece
Note the following:
• If the charging LED is not lit after the power is turned on, there may
be a problem with the base circuit. Contact Customer Service for
instructions.
• If the charging base terminals are dirty and contaminated, the handpiece
may not properly charged. Ensure all connections are clean prior to
using the charging base.
• Use only the charging base supplied with the CanalPro
TM
CL2.
• While the battery is charging the rear of the handpiece may become
warm which will not generally cause a problem.
• Once the handpiece is placed on the charging base it is recommended
that it stays in place until the battery indicates fully charged.
• A completely drained battery may not be able to be charged and may
have to be replaced.
• Avoid placing the charging base in an area that may be susceptible to
additional heat (in the sunlight or next to a heater, etc.).
• The battery may not charge if the temperature is excessively high or
low, it is already fully charged or if the battery is damaged.
4.3 The CanalPro
TM
CL2 Modes
• Auto Stop Reverse Forward – In this mode if the handpiece is
overloaded it will begin to run in reverse until the overload is relieved.