Colorjet VerveLED VLR 2513, Installation And Troubleshoot Manual

Page: 44 / 49

Page | 43 Verve LED
18. Troubleshooting
1. “Printer Not Initializing”
Problematic Parts Reasons Correction Steps
1. Emergency Switch Switch is Pressed Release the Emergency Switch
2. 220V AC No power supply to the Head
Board Check the Input/output Volt
Check MCB and ON it, if not
3. 24 VDC No power to SMPS output Check SMPS Output Power
Check 24 V power supply and
replace the Power Supply, if
faulty
Check the 24 V Power Supply
cable and replace it, if required
4. Servo Driver Error in display
No power to Servo Motor Check and try to resolve the
error on the display screen
Check the power connection
and replace it, if faulty
5. Main Board Factory settings are disturbed
Fault in Main Board Correct the factory settings
Replace the Main Board, if
faulty
6. Head Board Fault in Head Board Replace the Head Board, if
faulty
7. Encoder Sensor Fault in Encoder Sensor Replace the Encoder Sensor.
2. “Print Control Centre Not Showing “Ready”
Problematic Parts Reasons Correction Steps
1. USB Driver Driver is not installed Install the printer driver, if not
installed (Refer to the Installation of
Print Control Centre section)
2. USB Cable USB Cable is loosely
connected to the printer
USB Cable is faulty
Check and tighten the USB cable
Replace it, if faulty
3. Printer Not Initialized Refer to Printer Not
Initialized Section