Cole Parmer 05017-10, Manual

Page: 38 / 45

7-2 Vacuum Oven Cole-Parmer
Section 7
Maintenance
Door Alignment
Procedure
A good seal around the door is critical, particularly when operating the
oven with a vacuum environment. Therefore, the following procedure
should be performed carefully. Refer to the illustrations below and perform
the following.
1. Loosen, but do not remove, the four (two in both the top and bottom
hinge) screws securing the door hinges.
2. Loosen the three door bracket screws (located next to the control
panel) that hold the bracket to the cabinet.
3. Slide the bracket all the way to the right. Securely tighten the three
screws.
4. Loosen the two slide-adjust nuts on the bracket and slide the catch
outward.
5. Align the top door edge parallel to the top surface of the chassis to
within 1/16 inch.