Cole Parmer 05017-10, Manual

Page: 34 / 45

Table 9. Pressure at Atmosphere; Source U.S. Standard Atmosphere,
P.62 (NASA)
D/AC-Temperature/Vacuum Recorder Outputs
Connector pin P3 is the Temperature/Pressure Recorder Output interface.
Output pins P3-1 and P3-2 provide an output voltage proportional to the
chamber temperature, while the pins P3-3 and P3-4 provide a similar
voltage proportional to the chamber pressure. To begin calibrating the
Recorder Outputs, press the menu key until the upper display shows
D/AC, then press the SET key. The lower display will show CAL and then
enter the temperature D/A calibration (D/AT). Connect a voltmeter across
output pins P3-1 (+) and P3-2 (-). The upper display will show a number
that corresponds to the temperature output voltage. Use the UP/DOWN
arrow keys to adjust the corresponding display value to increase or decrease
the temperature output voltage then press the SET key to enter the new
value. The output voltage will be updated.
6-16 Vacuum Oven Cole-Parmer
Section 6
Operation
Pressure
Altitude (ft.) Inches of Hg Torr(mm of Hg) PSI
-1000 31.02 787.87 15.25
-500 30.47 773.83 14.94
Sea Level (0) 29.92 760.00 14.70
500 29.38 746.37 14.43
1000 28.86 732.93 14.18
1500 28.33 719.70 13.90
2000 27.82 706.66 13.67
2500 27.31 693.81 13.41
3000 26.81 681.15 13.19
3500 26.32 668.69 12.92
4000 25.84 656.40 12.70
4500 25.36 644.30 12.45
5000 24.89 632.38 12.23
5500 24.43 620.65 12.00
6000 23.98 609.09 11.77
6500 23.53 597.70 11.56
7000 23.09 586.49 11.34
7500 22.65 575.45 11.12
8000 22.23 564.58 10.90
8500 21.81 553.88 10.70
9000 21.38 543.34 10.50
9500 20.98 532.97 10.30
10000 20.58 522.75 10.10