10
Loading Coins
See Figure 10 for coin capacities.
•
To Load Front Tubes Only:
Tubes
A,B, and C can be hand loaded
without opening the cassette. By
pushing the Sorting Door Latch to
the left and swinging open the
Sorting Door (See Figure 12), you
can load coins directly in tubes A,
B,
and
C.
SECTION 2: INSTALLATION & SETUP
NOTES:
•
Make sure all coins lay fl at and fi ll each coin
tube to be used with at least 5 coins.
• For the most reliable operation, do not load coin
tubes above the 100% level marking.
• Even if all 6 tubes are being used, all tubes
must be left installed but disabled electronically.
For proper operation, be sure to disable coin
routing and coin level sensing for unused
tubes. For the Guardian 6000, use MENU/SETUP/
CASSETTE/CUSTOM and set unused tubes to “---”.
For the Guardian E6, use MENU+D and then press
the unused tube letter button.
Figure 8
Figure 9
Payout
Cassette
Release
Latch
10.
Load coins into the changer the tubes
using one of the following 3 options:
•
Using Swing Out Payout Cas-
sette
:
Rotate the Payout Cassette
Release Latch downward to open
the coin Payout Cassette (See
Figure 8). Pivot the Payout
Cassette out of the changer
housing to access the coin
tubes (See Figure 9). Once
the latch has been depressed,
the Payout Cassette must be at
least partially opened before
it can be closed and reset properly.
Fill the six coin tubes to the desired
levels with the appropriate coins.
Refer to the individual labels at the
top of the tube to determine which
coin denominations go in
each
tube.
•
By Removing Cassette:
The
cassette can also be lifted out of
the changer for loading coins.
Open the Payout Cassette and
swing it out, then lift the Payout
Cassette straight up to remove it
(See Figure 11). Load coins as de-
scribed above. Reinstall the
Payout
Cassette
by
fi rst positioning
it on the lower pin, then align the
upper pin and lower the cassette