Model 1450 I/O Expansion Module Installation & Reference
Precautions
Observe these precautions when installing an In-Sight I/O Expansion Module to reduce the risk of injury or
equipment damage:
•
Never connect the I/O Expansion Module to a power source other than 24VDC, and always use
the two pin 24VDC power connector on the I/O module. Any other voltage creates a risk of fire or
shock and can damage the hardware.
•
The 24VDC source must be the same source used by the Programmable Logic Control I/O.
•
Do not install the I/O Expansion Module in areas directly exposed to environmental hazards such
as excessive heat, dust, moisture, humidity, impact, vibration, corrosive substances, flammable
substances, or static electricity without a protective enclosure.
•
To reduce the risk of damage or malfunction due to over-voltage, line noise, electrostatic
discharge (ESD), power surges, or other irregularities in the power supply, route all cables and
wires away from high-voltage power sources.
•
The I/O Expansion Module does not contain user-serviceable parts. Do not make any electrical
or mechanical modifications. Unauthorized modifications may violate your warranty.
iii
Summary of Contents for In-Sight 1450
