Model 1450 I/O Expansion Module Installation & Reference
B.1.7 1450 I/O Expansion Module General-Purpose Output to PLC
Sourcing Input
The Model 1450 I/O Module provides 1mA of source current. If more current is required, a
1.0K Ohm 1W pull-up resistor can be added; connect one end of the resistor to the output and
the other end to a +24V OUT terminal on the I/O Expansion Module.
The corresponding LEDs will illuminate only when the outputs are activated in the pulled-up
state.
NOTE
The status LEDs for general-purpose outputs will illuminate even in the sourcing input case, where the
output is activated but the load does not detect a high (i.e., the pull-up resistor is not sufficient to overcome
the load resistance to ground). This is because the LED indicator is driven from the logic source at the
micro-controller and not connected directly to the load.
31
Summary of Contents for In-Sight 1450
