Section 2: Installing the In-Sight 1000
Installing In-Sight™ 1000 Series Vision Sensors
18
10
Click OK. The message box shown Figure 2-7 appears.
Figure 2-7: IP Configuration Message Box
11
Cycle power on the In-Sight 1000 by removing, then reinserting, the RJ-45
connector from the sensor's Breakout port. The message in Figure 2-8 appears
when the In-Sight 1000 is located on the network.
Figure 2-8: IP Configuration Successful Message Box
If the message in step 11 does not appear within one minute of cycling power, click
Abort. The New Host Configuration dialog will reappear. Verify that the IP Address is
valid and the Subnet Mask is appropriate for the local network. Make corrections as
necessary, and retry steps 1 through 11. Contact your network administrator if
problems persist.
