Fire prevention
1. ProWash 575 LX
uses a Philips 575 MSD or 575 MSR/2 lamp; the use of a different lamp may result in the damaging
of the fixture and cause the voiding of the guarantee.
2.
Never install the fixture on flammable surfaces.
3.
Minimum distance from any flammable material: 0,5 m.
4.
Minimum distance from the closest illuminable surface 2 m.
5.
Replace dmaged or blown fuses only with others of identical size and value, referring if necessary to the schematic diagram.
6.
Connect the projector to main power via a thermal magnetic circuit breaker..
Prevention of electric shock:
1.
High voltage is present in the internals of the unit; disconnect from mains supply prior to perform any operation involving
contact with the internal components of the projector,.including lamp replacement
2.
For mains connection, strictly adhere to the instructions outlined in section 7 of this manual.
3.
Given its high level of technology,
ProWash 575 LX
, needs the intervention of specialized personnel for all service appli-
cations. Always refer to you
coemar
center.
4.
A good ground connection is essential to the proper functioning of the fixture.
Never operate the unit without a proper ground connection.
5.
Never install teh fixture where it may be exposed to rain, or in extremely humid ambients. A constant supply of circulating
air is essential
Protection against ultraviolet radiations:
1.
Never turn on the lamp if any of the lenses, filters or plastic housings is damaged; their shielding action is effective only if
they are in perfect conditions.
Never look directly into the lamp when it is operating.
Safety:
1.
The projector should always be installed with bolts, clamps, and other fixings which are suitably rated to support the wei-
ght of the unit.
2
. Always use a secondary safety chain of a suitable rating to sustain the weight of the unit in case of the failure of the pri-
mary fixing point.
3
. The external surfaces of the unit at various points may exceed 80°C. Never handle the unit until at least 10 minutes have
elapsed since the lamp was turned off.
4
. Always replace the lamp if any physical damage is evident.
5
. Never install the fixture in an enclosed area lacking sufficient air flow; the ambient temperature should not exceed 45°C.
6
. A hot lamp may explode. Always wait for at least 10 minutes to elapse after the unit has been turned off prior to attemp-
ting to replace the lamp.
Always wear suitable hand protection when handling lamps.
Protection rate against penetration by solids and liquids:
1.
The projector is classified as ordinary appareil. Its protection rate against penetration by solid and liquid bodies is IP 20
3. Important safety informations
4
English
