After having gone thoroughly through the procedures so far described, proceed to power up your
DMX 512
mixer, which
will control the
ProWash 575 LX
; Subsequently connect the fixture to mains supply, and turn it on by means of the
power
switch. Once turned on, the projector will run the motor reset routine; this procedure, will last a few seconds,
allowing the step motors to reach their default positions before following the mixer’s commands.
DMX display
The dmx display on the base of the fixture lights up to indicate the
DMX 512
signal sent by the mixer is being correctly
received.
If the display is blinking, the fixture is not receiving any signal; check cables, connections and see if the mixer is functioning
properly.
function
display
menu enter
+
Set dmx 512 address
A O O 1
enter
A001
to
A493
9. Alimentazione
11
English
