Control signal is digital and is transmitted via two pair screened ø0.5mm cable as per international standards for the transmission of
DMX512 data. Connection is serial, utilising XLR3 and XLR5, male and female sockets located on the base of the
iWash Halo,
labeled
DMX 512 IN
and
OUT
(see diagram).
Plug/socket connections for XLR3 and XLR5 connectors:
Pin connections conform to the international standard as per the following table:
pin 1 = GND
pin 2 = data -
pin 3 = data +
If using a controller which output signal via an XLR 5 (5 pin) socket, do not use pins 4 and 5, leave them unconnected.
ATTENTION!!
Ensure that all data conductors are isolated from one another and the metal housing of the connector.
Pin number 1 should never be connected to the device’s power supply.
3
2
1
Controller
Standard
DMX 512
OUT
out
in
Ad altri
iWash Halo
Connect to other
iWash Halo
out
in
6. DMX signal connection
9
English
