GrAL
1) Press the
+
or
-
button until the display shows
GrAL
(for gobo alignment).
2) Press the
enter
button to confirm your selection; the display will show a numeri-
cal value which corresponds to the factory preset.
3) Press the
+
or
-
button until the numerical value corresponds with the correct ali-
gnment of the gobos on the rotating gobo wheel of all the
CF 1200 Hard
Edge
in the same installation.
4) Press the
enter
button to confirm your selection.
cLAL
1) Press the
+
or
-
button until the display shows
cLAL
(for alignment of the colour
wheel).
2) Press the
enter
button to confirm your selection; the display will show a numeri-
cal value which corresponds to the factory preset.
3) Press the
+
or
-
button until the numerical value corresponds with the correct ali-
gnment of the colour wheel in the optical path of the projector.
4) Press the
enter
button to confirm your selection.
PrAL
1) Press the
+
or
-
button until the display shows
PrAL
(for alignment of the prism
wheel).
2) Press the
enter
button to confirm your selection; the display will show a numeri-
cal value which corresponds to the factory preset.
3) Press the
+
or
-
button until the numerical value corresponds with the correct ali-
gnment of the prism wheel in the optical path of the projector.
4) Press the
enter
button to confirm your selection.
END
1) Press the
+
or
-
button until the display shows
END
(for completion of the elec-
tronic alignment procedure)
2) Press the
enter
button to confirm your selection. The display will revert to its nor-
mal operating mode and the internal memory will record all changes made.
Important Note
: At the termination of the above electronic calibration procedure,
if the END function is not performed, no memory changes will be effected. This
allows the operator to abort any changes made, in case of operator error.
function display
function display
function display
function display
