Instructions to assemble and install
Edition E0
Page 25 of 69
Confidential and Property of CoeLux S.r.l.
6.2.3
STEP 3
Insert the frame of the CoeLux® panel [5] (PN 73-00005-01) into its final position between the
panels ([1], [2], [3] and [4]) you have just assembled and ensure there are no obstacles for
assembly. Once you have checked whether it is inserted correctly, take it out and proceed as
follows.
Open the box and take out the CoeLux® panel [6] (PN 03-00001-01). Remove a few centimetres
of the protective film along the entire perimeter of one side. Place a thin strip of transparent
silicone on the inner edge of the frame [5] (PN 73-00005-01), highlighted in the close-up below
and in Figure 6. Take care the transparent strip of silicone on the CoeLux® panel is invisible.
Then, place the CoeLux® panel [6] (PN 03-00001-01) on the edge with the silicone, so it is sealed
and place the two pieces assembled in a dust-free area (even outside the clean chamber, but
covered with a polyethylene sheet and ensuring it remains untouched) for at least two hours to
allow the silicone to dry.
Fig. 9
Installation sequence - Step 3
Fig. 10
Installation sequence - Step 3
6
5
Edge on which the
thin strip of silicone
must be placed
External edge
Internal edge
Silicone strip