Instructions to assemble and install
Edition E0
Page 10 of 69
Confidential and Property of CoeLux S.r.l.
2.3.1
UNPACKING
N.B.:
You can start to unpack only after you have carried out the cleaning guidelines (see paragraph
3.5).
As the contents are fragile, we recommend you take maximum care.
1
Check the material delivered corresponds with the contents of the shipping documents. If
anything is missing or incorrect, contact CoeLux S.r.l. immediately.
2
Once you have opened the box, remove the various system parts from the internal
packaging.
3
Proceed to carry out a careful, scrupulous, general check to identify any damage to the unit
during transport. All damage must be immediately notified in writing to the haulier and the
manufacturer. Do not continue to unpack until you are authorised to do so by CoeLux S.r.l.
4
Proceed to assemble as indicated in Chapter 4.
5
Save and dispose of all the packaging material in compliance with the measures of the laws
in force.
2.3.2
HANDLING THE PARTS
All the component parts weigh less than 25 kg and can, therefore, be lifted and handled
individually without using lifting devices.
As the contents are fragile, we recommend you take maximum care.
We advise all operators involved in the operations described in this manual to use adequate
personal protective equipment (PPE), e.g. gloves, safety shoes, etc.
2.3.3
STORAGE
Store the unassembled unit in a closed room, protected from bad weather and under the
following environmental conditions:
-
Temperature between -20°C and +50°C.
-
Relative humidity below 30% at 40°C and 90% at 20°C and, in any event, non-condensative.
-
Atmosphere with clean air, with no acids, corrosive gases, salts, etc.
The unit must be accurately protected from dust and sunlight using protective covers and
stored away from any possible accidental impacts.