25
.
AFTER SALES SUPPORT
1300 663 907
MODEL: HE161192
SETUP
3.3.2 Inserting Filament
1. On the Main Screen, select ’Quick Menu’ > ‘Change Filament’> ‘Add Filament’
2. Select the desired type of Filament to be added. The Extruder will automatically be raised
and your Printer will begin heating the Extruder to the correct temperature. When the
temperatures are within a few degrees of the target, you are ready to insert the filament
3. Place the included filament onto the Spool holder. Carefully insert the end of the filament into
the hole on the Extruder. The Extruder will begin to slowly pull the filament in. Once filament
begins extruding, press ‘Back’ to stop
4. Carefully remove the extruded filament from the Nozzle Head and ensure the Print Bed is
clean
WARNING:
Extruder and Heated Print Bed will still be hot
3.3.3 Removing Filament
1. On the Main Screen, select ’Quick Menu’ > ‘Change
Filament’> ‘Remove Filament’
2. Select the desired type of Filament to be removed. The Extruder will automatically be raised
and your Printer will begin heating the Extruder to the correct temperature
3. Once the Extruder reaches the correct temperature, the filament will begin retracting from
the Extruder. Gently pull the filament up until it is released and press ‘Back’ to stop
NOTE:
Trim of the end of the retracted filament prior to reinserting into the Extruder to prevent
clogging the Printer Nozzle.
3.3.4 Storage
Both PLA and ABS filaments are sensitive to moisture. If stored in a humid environment, the quality
of the filament can deteriorate, with a tendency to bubble and spurt from the nozzle tip. This will
affect print quality, so when storing PLA or ABS for an extended period of time, follow these tips.
• Store in a sealed, air tight bag/container. We recommend a vacuum seal bag
• Store with a silica gel (moisture absorber) pack. One is included with each filament spool
.
Summary of Contents for HE161192
Page 1: ... MODELNUMBER HE161192 INSTRUCTIONMANUAL VERSION 1 ISSUED 23 11 17 ...
Page 2: ... ...
Page 40: ... ...
