EN
1. Press the red button and open the central buckle of the child seat.
2. Place the child in the car seat.
3. Make sure that the child has been placed correctly in the seat and that his back adheres to the
seatback.
4. Put the harness on the child's shoulders making sure that the harness straps are not twisted.
5. Join the plastic tongues of both harness straps.
6. Then insert them into the main buckle and press until you hear a click sound.
7. Pull the middle strap at the seat front to immobilize the child by the fastening system.
8. Finally check if all safety components have been properly fastened.
Harness adjustment in safety seat
Remember that all the belts fastening the child restraint in the car must be tight, the harness straps
must fit the child's body and must not be twisted.
1. To loosen the harness straps press the regulation device – the buckle at the front of the seat shell,
pulling both straps at the same time.
2. To tighten the harness straps pull the middle strap at the front of the seat shell until the harness
straps fit the child's body snugly.
Make sure that the lap straps are placed low so that the child's pelvis is securely restrained.
Installation of child safety seat in a car (Fig. A – F)
Never install the child safety seat in the passenger seat fitted with an air bag because it may cause
danger to the child's life.
Always install the child safety seat in a passenger seat in a rear-facing position.
1. Please set the carrier handle of the child safety seat and place it in the passenger seat (Fig. B)
2. Push the front passenger seat as far back as possible.
3. Pull out the car safety belt as far as possible and thread the lap belt through the upper slots in the
child safety seat. (Fig. C)
4. Fasten the safety buckle of the car seat belts. (Fig. D)
5. Then thread the car seat shoulder belt through the slot at the back of the child safety seat (Fig. E).
6. Set the safety seat carrier handle in the position preventing the excessive tilting of the seat during
the drive. (Fig. F)
7. When you have done all these things properly and made sure that the safety seat has been
correctly installed, you can drive off.
Car seat handle reglation (Fig. G)
To change the position of the handle, press at the same time the buttons on both sides of the handle
where it connects with the seat body and set the handle in the required position. When the right
position is found, the mechanism will lock again (you will hear a distinct click sound), and the buttons
will return to their previous position.
The handle can be set in four positions (Fig. G)
1. Position to transport the child safety seat in a car (Fig. G pos. 1)
2. Position to carry the seat ((Fig. G pos. 2)
3. Sleeping / rocking position (Fig. G pos. 3)
4. Sitting position – child seat for home use (Fig. G pos. 4)
Cleaning / maintenance of child safety seat
▪ The body of this child safety seat should be cleaned with warm soapy water.
▪ The seat cover can be hand washed in the temperature below 30oC.
▪ The washed cover should be laid flat to dry.
▪ Do not spin or tumble dry.
Removing the seat cover
▪ Undo the main harness buckle.
▪ Remove the fabric seat leveller.
▪ Pass the shoulder straps and the crotch strap through the slots in the cover.
▪ Remove the cover from the child safety seat.
Putting the cover on the child safety seat
▪ Thread the shoulder straps and the crotch strap through the slots in the cover.
▪ Put the cover on the child safety seat
▪ Put the fabric seat leveller.
▪ Fasten the main harness buckle.
