98-175666-A
Appendix F: Event messages
F-8
List of events
08842-0 ADM
WARNING GSC demodulator
The GSC demodulator has reported an error. (!V,!T)
08843-0 ADM
WARNING DVBS demodulator
The DVBS demodulator cannot be initialised and
loaded correctly. (!V,!T)
08844-0 ADM
ERROR
BUC voltage out of
range
The BUC voltage is out of range. (!V,!T)
08845-0 ADM
ERROR
LNB voltage out of
range
The LNB voltage is out of range. The LNB might be
switched off to protect the power supply circuitry.
Reactivate satellite profile to try again, check LNB
cable and surroundings if the problem persists.
(!V,!T)
08846-0 ADM
ERROR
AIM-O supply voltage
out of range
Supply voltage measured at AIM-O is not within
expected range (!V,!T)
08847-0 ADM
ERROR
AIM-O Master PLL
lock
The AIMO master PLL has lost lock. Check the input
reference signal. (!T)
08848-0 ADM
WARNING TX Calibration
missing
Tx calibration not performed. (!T)
08880-0 ADM
ERROR
WLAN configuration
error
Configuration of WLAN module failed. (!V,!T)
08881-0 ADM
WARNING DHCP Client address An IP address was received from an external DHCP
server that overlaps another VLAN. Traffic on these
VLANs may be unpredictable. Reconfigure the
server or IP settings of that VLAN.
08A00-0 ADM
WARNING GX Core Module fan There is a problem with the Core Module fan.
Check/clean and replace if necessary. (!V,!T)
08A01-0 ADM
WARNING GX Core Module
heater
There is a problem with the Core Module heater.
Check and replace if necessary. (!V,!T)
08A02-0 ADM
WARNING GX Core Module
temperature
The Core Module temperature is out of range. This
may affect performance, and the Core Module will
be shut down if the situation gets worse. If the "GX
core module heating" event is also present, the
internal heater is currently warming up the unit to
its operational temperature. (!V,!T)
08A03-0 ADM
ERROR
GX Core Module
power
The Power Good signal from the Core Module is
low. The issue can either be: - Internal Core Module
or internal cable failure - Temperature of Core
Module is too high and it has been turned off (*) -
GMU has been manually switched off on the front
panel (*) (*) = Only on systems with GMU. (!V,!T)
ID
Module Type
Description
Explanation
Table F-1: Event messages (Continued)
